Ducting Bends

Ducting Bends

In a ducting system, bends are often a potential problem area either due to increased friction as the air changes direction, or they can be more likely to block requiring constant inspection especially if the diameter or air speed have not been correctly calculated.
Our SMOOTH PRESSED BENDS result in less wear and lower running costs due to less turbulence ie better airflow.
Our smooth pressed bends have no welds that can open up as they resist the flow of particles less.
Reduce friction loss and save power!
If a bend does need replacing it can be replaced in ‘minutes’ without stopping production, and a 1mm galv bend can be substituted with a 2mm bend if the conveyed material is very abrasive.
Larger diameters frequently are manufactured as SEGMENTED BENDS. While there is some compromise in airflow, at these diameters it is not critical.

Looking for the right solution for your Industry?